Liczymy pasujące modele…
This is a slightly bigger than usual Lego style lightsaber. I built it as an accessory for an oversized Darth Vader figure. Designed to fit a Ledlenser K2 torch in the base to light up the blade. How bright the blade is depends a little…
A simple Stormtrooper keyring. You will need to set a colour change for layer 11 and get a hold of a key chain to attach. I printed mine in PETG as I was living in a very hot country. So far it has lasted well but I haven't used it for…
Entry dome for Lars homestead, designed to be slightly buried. 2 stair pins can be used to align the stairs to the main dome and then glued. I used basic decorators filler to add texture to my print and then painted it. No support was…
A whole mix of basic props used to decorate a Lars homestead project. Could be used for table top gaming. Other than the mushroom shaped one they should all be printed as is and without support. Turn the mushroom one upside down to print.…
The pit for Lars homestead. It's the biggest single thing I have printed. I used a large shelf to build the pit on top of. It required a lot of filling to cover the gaps between sections and to add the texture to all the walls. Most…
My simple version of a vaporator like the ones found at Lars homestead. Only parts that need supports are the out bits. There are 3 variations of section 3 that can be printed. Section 4 can only be used if option 1 was used for section…
Really simple EG-6 and WED 15 droids. You need to print 2 of the EG-6 feet and 1 of all other parts. Then glue together for assembly. Supports may be needed under the WED 15 body. You should be aware these files are an absolute mess! I…
The top of the workshop on Lars homestead that can be seen on the surface. You need to print 4 of both the top and bottom sections. I only used supports under the connector pins. Once printed I glued the sections together, filled any…
To wszystkie aktualnie dostępne wyniki.
