Liczymy pasujące modele…
Test base for ATX/mATX/ITX motherboards (20mm height). Test base for motherboards in the following formats: ATX, mATX, and ITX. The motherboard height above the table/worktop is 20mm. Designed to allow the motherboard to be…
The test model was printed using PLA filament (62/60°C bed, 225/220°C print). The front of the case is set back 5mm from a typical drive mounted in a 5.25" computer bay. The floppy drive is attached using screws from the center of the…
A mounting/spacer pin for testing/starting up 15 & 20mm-high motherboards. A pin/stand for motherboards of any size. The board's height above the table/worktop is 15mm. This provides a ~1mm gap between the bottom edge of the bracket and…
Fan mount (1x60 or 2x40) for a 1U heatsink - NOT FOR 1U chassis. This mount is designed for mounting on the SuperMicro X8SIL-V motherboard heatsink. This mount is NOT INTENDED fot 1U chassis. The asymmetrical fan mount was designed for…
Bezel/panel for Thinkcentre. Slim CD/DVD + 3.5" Floppy. The bezel is mounted using M2.5 screws. Designed for use with the bay from the project: " 5,25 to FDD+slimCD/DVD " ( https://www.printables.com/model/1521390-525-to-fddslimcddvd ).
Replacement for a full front panel with a 5.25" drive cutout in ThinkCentre M series computers. Attach the bezel to the back of the front panel using M2.5 screws no longer than 4mm. Printed using PLA filament.
A 40mm fan mounting structure for PC104 expansion card slots. Two pieces are available as print files: the structure and the securing clips, which must be printed in batches of four.
To wszystkie aktualnie dostępne wyniki.
