Liczymy pasujące modele…
TPU filament is recommended Stiff filaments may damage the case during assembly. UPDATE: I created new better model. Better fit, now you can print with PETG. Tested - showed on photos. ( The holes don't look very good because it was a…
Heigth: 10cm Width: 8cm Hole: ⌀ 3,8c
I made it for cap holder in my Audi A6 C5. For best quality I recommend print in position like on foto.
small fan in case for DC motors with 2,5mm shaft. (you must use glue to close case)
Pendrive case replacement
I created a model of this handle to replace a broken handle in my toolbox. You need 2x ϕ3mm pins to assembly it.
This is left-handed version but you can mirror this ( leads for strings have 5 deg tilt for better fit)
Small cable label where you can add in slicer number or symbol. Fastended by zipper.
you can mirror model if you need.
This holding pin is complementary part to linked model :) Its not remix but I want to be easy to find. Thank you Thoro for your model it fits well in my car ;)
To wszystkie aktualnie dostępne wyniki.
