P
Printablesdrewmoseley
ESP32 D1 Mini Case Bottom with Pin Access
Just a slightly modified version that adds GPIO pin access.
- Pobrania
- 182
- Polubienia
- 17
- Ocena
- 3,5
Wszystkie modele
Liczymy pasujące modele…
P
Printablesdrewmoseley
Improved Wandering Hour Clock - Modifications
These are slightly modified parts for the wandering hour clock. I made the Numberwheels a bit thicker and enlarged the hole for a heatset insert. The screws I was originally using poked through the front of the original parts so I made…
- Pobrania
- 164
- Polubienia
- 52
- Ocena
- 0
P
Printablesdrewmoseley
Unfolding James Webb Space Telescope (JWST) Sunshield Template
I had trouble making the sunshield from the descriptions in the other models. I created this as a template that can be glued in place using either Elmer's Glue or CA Glue. The spars can then be cut off with a pair of wire cutters and you…
- Pobrania
- 94
- Polubienia
- 17
- Ocena
- 5
P
Printablesdrewmoseley
Sovol SV04 Springsteel Sheet Bed Alignment Tabs
Bed alignment tabs for the Sovol SV04.
- Pobrania
- 60
- Polubienia
- 10
- Ocena
- 0
P
Printablesdrewmoseley
Slim Raspberry Pi Zero WH / Zero 2 W Base with SDCard holder
I wanted some slots to hold a few extra SDCards. Supports may be needed depending on your printer.
- Pobrania
- 42
- Polubienia
- 11
- Ocena
- 0
P
Printablesdrewmoseley
ESP8266 D1 Mini Case Pins Exposed
This is a simple case for a Wavgat branch D1-Mini. I could not find one that fit this specific board with the pins exposed so I created this.
- Pobrania
- 34
- Polubienia
- 1
- Ocena
- 5
P
Printablesdrewmoseley
ESP-F Devkit V4 Case - Pins Exposed
This is a pretty simple build. You may need to enable “Print Thin Walls” or whatever the appropriate setting is in your slicer.
- Pobrania
- 31
- Polubienia
- 3
- Ocena
- 0
P
Printablesdrewmoseley
ESP32 DevKitC Case Lid with Antenna
Just added a short hole to allow the wifi antenna through.
- Pobrania
- 23
- Polubienia
- 2
- Ocena
- 0
P
Printablesdrewmoseley
Sunlu S1 Filament dryer mount for RepRack - Modified
I used a wood french cleat across the entire width of my Reprack and needed a bit more clearance on the back.
- Pobrania
- 21
- Polubienia
- 9
- Ocena
- 5
P
Printablesdrewmoseley
Yubikey Keychain Sleeve
This is a modified bottom piece adding a cutout for a 19mm x 6mm x 2mm bar magnet.
- Pobrania
- 12
- Polubienia
- 1
- Ocena
- 0
To wszystkie aktualnie dostępne wyniki.