Liczymy pasujące modele…
Tennis Ball Thrower to play fetch with your dog. This was printed diagonally on an Ender 5 Plus and has an overall length of about 16.5in. Printed at 50% infill with 4 wall count and supports touching baseplate.
This is a hitch cover for a 2 inch receiver. The spring allows for easy install and removal to keep debris out of the receiver. I also included the F3D in case you wanted to inlay a custom design.
Screw in funnel to fit Rb20, RB25, and RB26
Door handle interior trim for the R33 Skyline. Modeled off a series 1 GTST.
Back cover for an S1 R33 GTS-T headlight. Printed the cover in ASA and the gasket in TPU. Tree supports everywhere.
There are 2 versions on the model: One model that is a solid piece and the other has a small slot to slide the seat belt through so you do not have to remove any interior pieces to fit the piece.
The clip that holds the grille. This was printed using Formlabs Tough 2000 engineering resin for resolution and strength. There is 2 sizes provided. The smaller of the sizes worked for my grille but could've had a touch more length to it…
R32, R33, R34 Nissan Skyline Rear End Outlines
Rear seat belt guide trim for the R33 Skyline.
Suzuki K6A Clutch Alignment Tool modeled for a JA22W Jimny. Printed with 3 walls and 10% infill out of PLA+. Outer diameter: 19mm Teeth: 18
HKS sign made with LED rope lighting. The sign measures roughly 12.75in W x 5.5in H. Extruded track on the back to route hidden wires. I used the following LED rope lighting from Amazon which leaves plenty of left over LEDs for future…
To wszystkie aktualnie dostępne wyniki.
