Liczymy pasujące modele…
Shover drain cover (Viega) and strainer. I recommend to tilt it 50° to minimize supports as I tried to apply the same curvature as the original. I recommend to use supports on the strainer only for the horizontal parts.
The balcony door handle broke, and I couldn’t find the exact replacement on Printaworld. So I modeled this one based on the original. The holes for the screws are approximately 47 mm apart . There are two versions, rounded and not.…
Imported from thingiverse. Onshape model .
I lost one of them, so I measured the one I still had on the other side and printed a replacement in TPU. Use 5–15% infill depending on the hardness you want.
Print it from a flat side to avoid supports and have the layers in the correct orientation to maximize resistance of the thin fin.
Paperclip tree. You will need six 8mm diameter magnets. Ideally at least 1 cm long.
Our rice cooker handle broke, so I designed a replacement. Here is the onshape page Print Settings Rafts: Yes Supports: Yes (print at an angle to minimize them) Notes: Done in ABS/ASA to withstand the heat. Category: Kitchen & Dining
To wszystkie aktualnie dostępne wyniki.
