Liczymy pasujące modele…
When assembling my Voron 2.4, I found holding the belts in place while I put the mount on for the StealthBurner was tricky. I created this clamp that holds the belts in place making installation so much easier. This requires you to remove…
This is a remix of Jake90's display case. I made a few changes to fit my needs. I am working on upgrading my RatRig VCore-3 to the 3.1 version and adding an enclosure. Because the plexiglass for the enclosure covers all the extrusion, I…
Designed this to hold my Bondhus hex drive set ( Amazon ). Will probably work with other sets, but have not tried them. Print the Hex Drive Storage file and Mount. The mount uses m3 inserts. Connect the two parts with 3 m3 x 10mm screws.…
Honeycomb Storage Wall mount for Klein Tool Hex Nut Drivers ( Amazon ). Label file can be used for multicolor prints. UPDATE 6/20/2023: Changed the base model to have the recess for the mounts be orientated correctly. Turns out I had…
While building my Voron V2.4, I found it necessary to turn the printer on it's side to access the electronics. The first time I had to do this after mounting the skirts, as I was rotating it, I heard a loud crack. After reprinting the…
Using the step file from the original model, I increased the area for the wires. I also added a lip to the bottom to hold the clip in place. It snaps over the arm and does not need anything to keep it there. Print standing up on the large…
I have been using loose brass inserts as nuts for mounting my BLTouch because regular nuts can be really difficult to put on. I have had problems of dropping the inserts when trying to install or remove them. I made this to embed the…
To wszystkie aktualnie dostępne wyniki.
