Liczymy pasujące modele…
(Must be credited if you use this bracket commercially!) Workaround for the strum fix plus 2 from bytearts if you want to use kailh box switches instead of pre-soldered low profile switches. You can use cherry, but I wouldn't recommend…
A backplate I traced from a top-down view of a GTX 1080 mini to fit onto a GTX 1070 mini. Print Settings Printer: Sovol SV01 Rafts: No Supports: No Resolution: 0.2 Infill: 20% Filament: Duramic 3D PETG Notes: Make sure not to use PLA, or…
A replacement tip for GH whammy bars if the original is missing or chewed up. This part is designed to be printed in TPU with no supports. The World Tour/GH5 variant must be printed lying on its side with supports on print bed only.
This is made to be printed in TPU and then glued together. I used super glue, but any kind of high strength glue will work fine. You can either glue it together while it's on the cable, or glue the boot together first and route the cable…
I thought the original knob on the Hi75 looked a bit dorky, so I decided to model some new ones. There are three variations of the knob. Lumpy, smooth, and knurled. All variations have a ring on the face which can be filled with an accent…
I had a couple kiosk guitars that had damaged cables and they were both damaged near the cable boot, so I thought I'd design a replacement for it! This is made to be printed in TPU and then glued together. I used super glue, but any kind…
Was bored one day and decided to make some new fret buttons for the DS Guitar Hero grip. Comparing them to the stock ones, they have a slight curved profile and fit just like the old ones! Modeled a replacement paper insert as well to go…
Make your antique desk fan safer! This is a replacement isolator for General Electric Big & Small Motor Yoke fans. It's made to be printed in 95A TPU, and designed to print vertically with supports disabled. Slides on easily and doesn't…
To wszystkie aktualnie dostępne wyniki.
