Liczymy pasujące modele…
This is a fake/dummy battery that allows you to use any larger battery (eg AA or AAA) instead of the low-capacity CR2032 You will need 3D print "part +" 3D print "part -" copper washer (used as "+ contact") M14x20x1 -…
Vertical magnetic marble run on a white board. Note: This is work in progress. I will keep adding new rails as I design it You will need (TLDR): Magnetic Whiteboard Some 16mm wooden or 3D printed marbles Magnetic foil/sheet 80 g/cm2 +…
Ikea recently introduced very nice, cheap and useless containers. However adding these distancers/legs into a corner allows conversion to stackable containers Print settings: sharp corners need time to cool down so either print 4 at once…
Allows you to hang two controllers on a vertically placed Xbox One S/X Print Settings (use anything you like but my recommendation is): 0.3 mm layer height no infill 3 bottom/top layers set rear seam and place it so that a seam is at “the…
65mm leg extender for ikea sniglar bed Category: Replacement Parts
To wszystkie aktualnie dostępne wyniki.
