Liczymy pasujące modele…
I print mine in ASA filament. You can also print it in Petg. Infill needs to be 100%. You will need a BNC female to female bulkhead connector 1 M4 x 18mm bolt with nut and washer 1 M4 x 16mm bolt with nut and washer 1 M4 thumb nut 14 gage…
These are bipod legs that work with the AX1 clamp that was created be K6ARK. you can find the clamp here on pintables. https://www.printables.com/model/626212-elecraft-ax1-ax2-antenna-bipod-clip-knob
I have created a small portable knee board for the elecraft kx2. You will need a strap of some kind 1"½ wide . 2.5mm elastic shock cord and a large fender washer. I recommend sizing the fender washer to fit after printing the board. When…
Elecraft KX2 VFO knob Recommended 100% fill no supports needed. I used ASA but petg would also be fine.
You will need some 2mm shock cord and lido mount of some kind. I use the simple cup holder mount from LIDO. Also you can print the spacer that will mount between the lido ball mount and the bracket. I use this to hold my clip on light.…
This is a stand that is for desk use or in the park. Any where you need to operate from. You can print this in any material you want I printed mine in petg. 15% infill no supports. You will need 2 10mm dia x 4mm thick. Not in the pic is…
Desk Stand for the Elecraft KH1. You can print it using PLA Or better. Infill 15% walls 2. Supports a must. I used Auto tree supports. The tabs on the sides are for Shock chords same as I used on my knee board.
You will need a section of 1/8 shock chord and Reflectix. But for the shield you can use any material you want. In one of my photos I used a paper plate. See video I created
To wszystkie aktualnie dostępne wyniki.
