Liczymy pasujące modele…
I maked this modell, I took some picture so you can make it easier. the first try was with finder 24v relay 8A its not enough! the secound try with a car relay(16A) works fine Use lot os hot glue… if the circuit is good then when you…
I made this modell for universal nixie motherboard you can find it on ebay or aliexpress. I used original rft socets and m3 srews. you need to glue the socets holder on the housing and the legs to housing.
i made for lancer x from 2008-2016 print with no support and pla 100%infill
you need to insert the socets first and solder the cables after some super glue the socet base on the housing and the legs for the housing. Afte you can put the electronic on theback cover insert the tubes the front panel and enjoy it:)…
i made it for wall use 2 srew to fit. Pla or petg.
For millenium modell, need support print with 100%infill from pla
print with support petg or asa
you can use any type of rounded tubes with diemsion 30mm. you need to have original socets or printed socets for the tubes. the socet holder neded to be glued for the housing. the kit:…
For the millenium modell print with pla 100%infill
Ezt a dobozt a diynixie-nek készítettem 12 órás készletben. A prototípuson hátul és elöl lézervágást használtam, de készítettem egy 3D modellt a hátulsó és az elülső oldalra, hogy könnyen kinyomtathasd. A lábakat a házhoz kell ragasztani.
its for rft z568m tube ore simular. Print with pla 100%infill. I used old cumputer dsub connector pins and put it with soldering iron.
I made it for gaggia baby millenium. USE PETG
for Kees Soeters wifi nixie clock using 6 z573m rft tube
I haven't printed it out yet, but it should be accurate to size. If you print it out, please share it with me. Print with asa or abs and 100%infill
steam knob for gaggia classic, i used hungarian 5forint and cut in half and hammered in, you can use any metal with 1,5mm thikness
I made for my millenium modell mode from petg and 100%infill. Nedd support
I haven't printed it out yet, but it should be accurate to size. If you print it out, please share it with me.
i working on it but i think ist alredy can be used. I also aded the fusion file you can customise it.
I used 3dprinre nedels and printed with pla. use som heat to get the nedels in plase.
Its For the first modell primo, Uses 2 metal 2mm thiknes and hammered in. Print with asa or abs or maybe petg. Use 90%infill.
To wszystkie aktualnie dostępne wyniki.
