Liczymy pasujące modele…
A low profile USB drive, SD card and micro SD card organizer. Can be printed with whatever settings. IMPORTANT: Friend tried this model without scaling and had issues with a very tight fit in the usb and SC card slots while I had no…
Two models to allow one to mount a PointSharp or RSA security token to a regular ID-card holder. Beware: These models are intentionally designed to have low tolerances. You may have to scale the model up a percent or two if your security…
A super slim case for a raspberry pi zero or zero W. Does not require any screws or mounting hardware. Simply print the two halves, slip the bottom with its' pegs through the holes of the raspberry pi zero. Then slip the top part over the…
The switch plate to a small Raspberry Pi Pico powered keypad. Switch holes are sized for Kailh switches, similar sized ones should fit. This keypad is designed to fit four M3x10mm socket head bolts and four M3 nuts. The bottom case…
The case to a small Raspberry Pi Pico powered keypad. The case has a mounting point for a Raspberry Pi Pico where two pegs can be squished with a hot metal object securing the Pi Pico. This keypad is designed to fit four M3x10mm socket…
A small and filament efficient cable holder designed to be used with 10mm wide hook-and-loop straps. Works well under desks and behind shelves. The holder is roughly 77mm long, 17mm wide and 4mm thick at the ends. The screw holes are…
A small cable channel designed to mount on the underside of a desk placed close to a wall when mounting to the wall would be difficult. It should be printed standing up, as it does in the picture, and at 100% infill. If it is too short or…
Remixed from Headphone hanger by Sebastian Grans. The inside face has a hole for a 20 mm diameter and 5 mm tall magnet.
Small and slim wall mount plate for the old style Philips Hue dimmer. Designed around use with a 16x2.5mm disc magnet. Printing settings don't really matter but recommended is to keep it backside down with support turned on and something…
A remix of Wansview Webcam Mount Adapter for webcams of similar sizes where he cable comes out the back. Can be printed with the screw en sticking up and support(only build plate) turned on.
A spacing block to allow more secure wall mounting of the Ikea PINNING coat rack. My recommendation is to print four of these at a higher infill rate than normal prints, I printed at 40%. When fastening the Ikea PINNIG to the wall simply…
To wszystkie aktualnie dostępne wyniki.
