Liczymy pasujące modele…
You may have to split the part in the middle in your slicer, depending on your printer. This will not fit all fire extinguisher brackets, so you may need to change the hole location depending on your bracket.
Switch shroud for SW20 MR2 instead of the ash tray. you have to tap the the back holes where the ash tray was mounted.
Wallmount that hooks on the underside of your R34 and is mounted witch a 5mm screw.
A Phone charger with card storage for the front cupholder to directly connect to the front USB Port for easy Android Auto access. You will probably need to fix the USB C Cable in place with either superglue or modeling patty, wich works…
Base und Logo extra drucken um das lackieren leichter zu machen.
The cheap version of the original mug holder. Print Settings Printer Brand: Ultimaker Printer: Ultimaker 2 Rafts: Doesn't Matter Supports: No Resolution: 0.1-0.2 Infill: 7-30% Category: Games
Support density shouldnt be too high. Not higher than 20% otherwise its a pain in the a** to remove it. You may have to sand the pins a little bit, depends on the print resolution of your printer. Print Settings Printer Brand: Ultimaker…
Power brick mount. 55mm x 40mm. With a 5mm hole for screws. You can also add zipties for cable management.
Inner dimensions of the part are 20.5x6mm, you also need a M5 nut, a M4 threaded insert you need to insert witha a soldering iron and a tapered M4 bolt. A bit of sanding may be required, depending on your printer settings. best printed in…
Dimensions are a snug fit with PLA,ASA…, when using TPU, wich i recommend, adjust the sizing to 98% in your slicer to make sure the ring fits best.
Case for HEUER Stopwatches with a Diameter of 54mm. When slicing add a pause one layer after the magnet holes are visible. fits 6x2mm round magnets in the lid and bottom piece of the case, you may have to use a bit of superglue to hold…
Penta esport keychain print with support Print Settings Printer Brand: Ultimaker Printer: Ultimaker 2 Rafts: Doesn't Matter Supports: Yes Resolution: 0,15-0,6 Infill: 3-100 Category: Accessories
.. Print Settings Printer Brand: Ultimaker Printer: Ultimaker 2 Rafts: Doesn't Matter Supports: No Resolution: 0.1-0.2 Infill: 20% Category: 3D Printer Accessories
A Digital Elevation/Depth Modell of the Wörthersee in Carinthia with data from KAGIS. Made with QGis and the DEMto3D Plugin.
To wszystkie aktualnie dostępne wyniki.
