Liczymy pasujące modele…
a nearly universal mount for a KUSBA accelerometer some times mounting the board hanging off the end is necessary for the usb cable to clear the umbilical note: the hole pattern is different to the adxl345 uses a screw to clamp to the…
a replacement key for TLR-7 Sub to move it about 5mm back to better align the rear buttons with the trigger guard of some 1913 railed pistols
adds a air assist to a 40 mm diode laser engraver. should give you slightly better cutting performance by clearing ash from the cut and increase the life span of your laser diode by blowing the smoke away from the lens. tested on my…
a handle for the covert instruments practice core to be held in your hand. must be imported as imperial not metric.
the tubes wow stick sends the bits in are probably the worst possible way to use them, here's the second worst. 56 slightly over sized holes to fit all the bits, plus 1 for your favorite or something no supports, brim, or raft, i printed…
mounts a meanwell supply to your rook 2020's underside, or any side for that matter, needs 2 m5 x10, 2 m3 x10, 2 m3 and m5 t nuts, and 4 m4 x im not entirely sure the cover uses 2 m5x10 and 2 m5 tnuts
5mm chamber thermistor mount you will need to print this in something that can handle your expected chamber temps, i chose ABS. parts needed thermistor m3 x8 socket or button head screw m3 t-nut
the oringinal bed did not work with the same 20mm springs as the previous revision, and caused the screws to be too short, while having 0 clearance for the heating pad which was left pressed against the frame. uses the thumb wheels from…
holds a 40 mm fan on your orange pi 3 lts
side supports for 3018 cnc machine with the intent of having send cut send, pictured are 1/4" aluminum
electronics tray for pico and orange pi lts 3 for rook 2020 preview image is outdated, bottom mounting holes are above the corner bracket in the original, this has been fixed in the step and stls. 4 m5 x10 screws 4 m5 tnut 1 m3 x10 screw…
a thing to sort harbor freight punches, with a little tray for some reason. does not retain punches, just holds them in order from largest to smallest. takes about an hour to print(.2 layers, 13% infill, on my fast voron trident profile)…
a cable management solution for the rook 3d printer
Quick and dirt case for the wise block requires 3 m3 by 20mm socket heads and 3 heat set inserts battery compartment over sized so add foam to protect the batter (designed for 3000mah)
To wszystkie aktualnie dostępne wyniki.
