P
PrintablesSJ- Homemade
flash forge adventurer 5m pro filament holder
everything should be to scale. ( long is for 1kg spools). set infill heavy if worried its too weak.
- Pobrania
- 320
- Polubienia
- 26
- Ocena
- 5
Wszystkie modele
Liczymy pasujące modele…
P
PrintablesSJ- Homemade
FLASHFORGE 5m Pro Top Lid vent tabs
top vent tabs for the flashforge adventurer 5mm pro. i was always putting something in the top to prop iit open especially with PLA. the fit snug in the corner and easy to print. a standard .2 profile works fine
- Pobrania
- 260
- Polubienia
- 32
- Ocena
- 5
P
PrintablesSJ- Homemade
adventurer 5m pro tool tray
needed a tray for all the extras i have next to my printers. simple tray for the front of the 5m pro. it slips right on and will hang with no problem. auto support works good. .2 profile. nothing special.
- Pobrania
- 151
- Polubienia
- 24
- Ocena
- 0
P
PrintablesSJ- Homemade
Flashforge AD5M Pro removeable top mount filament holder
top mounted filament holder for flash forge AD5m PRO mounts to front right corner with lid down. Lay on side with flat bottom of roller use supports and paint in to the hexagons as well to the flat spot on the roller
- Pobrania
- 147
- Polubienia
- 31
- Ocena
- 0
P
PrintablesSJ- Homemade
dessicant tray for sterilite 18"x 14" tub
a nice large dessicant tray that can be used in any larrge box. i specifically made the for the large 18" x 14" sterilite containers. works very well even with one but made to be a plate on the bottom if you print 4. .2 settings will…
- Pobrania
- 32
- Polubienia
- 6
- Ocena
- 0
P
PrintablesSJ- Homemade
D12 Dice WINNER WINNER CHICKEN DINNER
its a pretty easy print, just make sure to orient "4" to the build surface as it will put the wording on the top. it can be printed comfortable at most sizes just dont go below 50 %.
- Pobrania
- 15
- Polubienia
- 2
- Ocena
- 0
P
PrintablesSJ- Homemade
larrge bit holder for aerospace drill bit sizing
needed a large bit holder for my bits. i use pretty specific sizes daily .(¼, #11,#21,#30,#40) prints .2 nicely i print most at .16
- Pobrania
- 8
- Polubienia
- 0
- Ocena
- 0
P
PrintablesSJ- Homemade
measuring tool tray for presicion calipers and squares
i made a holder for all my measurement tools. i felt like they were always under something or in the wrong place. it holds the measurement tools from the harbor freight kit. As well i added the hexbit holder and 2 pockets for small stuff…
- Pobrania
- 8
- Polubienia
- 0
- Ocena
- 0
P
PrintablesSJ- Homemade
mossy oak dehydrator stand for filament
i made a center mounting point to put in a mossy oak or equivalent food dehydrator. simple design and mounting is simple just place over the top. and print tubes depending on how high you make the walls of your dehydrator. i used 2 poster…
- Pobrania
- 6
- Polubienia
- 0
- Ocena
- 0
To wszystkie aktualnie dostępne wyniki.