Liczymy pasujące modele…
This helper holds two wires together so you can hold the solder and soldering iron. This is a remix of a great design by PeterLandin. I needed something a bit smaller, so I reduced the size and added a couple more slots for various wire…
Case enclosure for a 5V One Channel Relay Module similar to the one linked below 5v Relay on Amazon
I liked the case plasmata designed, but needed more space beneath for easier pin access. This version provides more space and an unnecessary vent on the lid. ***UPDATE: Added a base version with two holes for wire access.
Little four piece puzzle fidgets. Quick to print and fun to play with. Print four of each STL file for a complete puzzle.
Chassis stand for the Axial SCX24 micro crawlers Designed fairly generic so it should fit most crawlers.
This is an enclosure case for the NodeMCU V3 development board and base. ESP8266 Development Board NodeMCU V3 can be found here: https://www.amazon.com/dp/B07DK2LRJJ/?coliid=I37O15QSY8H0VA&colid=1PKM0NV2CRFRC&psc=1&ref_=lv_ov_lig_dp_it
DS18b20 temperature probe holder for probe measuring 6mm OD x 50mm length. Use double sided tape for mounting.
Replacement throttle trigger for the Stihl FS40 string trimmer Assembly tips: Use a hack saw to cut the slot for the throttle cable to rest in (see top of trigger in assembled picture) Sanding of the pin may be required to fit into the…
This slim Philips Hue Dimmer Switch Plate has an integrated pocket for a metal disk or washer (1 x 19mm). Two design files included, one with mounting screw holes and one without.
Simple Lutron Caseta Pico remote (Model PJ2-3BRL) wall mount holder. Double sided tape or Command Strip would work best to mount. Credit goes to ccmake: https://www.thingiverse.com/thing:5383306/files
Rubic’s Cube stand. Can be personalized with text on the faces.
A pipe depth setting tool designed for use with Copper, PEX or CPVC Pipe. Insert pipe into the appropriate size (1/2" or 3/4") and mark a ring around the pipe to indicate proper depth for the SharkBite Push-To-Connect fittings to ensure a…
This is a bracket mount for the DHT22 temperature and humidity sensor. double sided tape can be used on the bottom or there’s a relief for a round magnet (12x2mm magnet size).
This is a fun and very challenging puzzle that can prove to be difficult without the solution sheet. The smaller puzzle pictured was printed full size (which is pocket sized). The larger one was printed at 150%. You'll need 1 large block,…
To wszystkie aktualnie dostępne wyniki.
