Liczymy pasujące modele…
Wanted to make a print in place large cable reel. Middle spinner is print in place. To eliminate all supports I made body in two pieces plus a crank handle. I was able to fit a 10m (30ft) #14 insulated extension cord. It was a tight fit…
Simple headphone mount. Attached to wall using 1 screw. Print on the back side of model (as shown). I did not need any brims or rafts but if you had some issues with sticking a raft could help. Under a hour print using 0.6 nozzle @0.3mm…
14mm hooks 50mm wide 23mm tall 30min print on Stock MKS3+ except 0.6 nozzle. Printing PLA with 4 perimeters, 25% infill. Using to hold 10lb sawhorses, but could be used for tons of different things.
Originally Designed to be a wall mount for controllers, but an be used for anything that fit. Design was to be as minimal as possible. Arms are fairly thin, which gives them flexibility, even with PLA. Help in place with 1 screw. Simple,…
Simple Fast model for book marks. Great for the end of spools, to use that last little bit of filament. Under 3.7g of filament for the largest book mark (if not scaled) 12min print with 0.6 nozzle at 0.3mm or 16m print with 0.4 nozzle at…
To wszystkie aktualnie dostępne wyniki.
