Liczymy pasujące modele…
A selection of car dashboard warning lights for a Christmas tree. Includes ABS, check engine, and tire pressure in both hollow and medallion form. Color swap with black base and Prusa orange PLA looks great. Some additional car parts…
This is a wash bucket standoff to keep sand and other grit from getting stuck in your sponge and other tools. Just insert the standoff into the bottom of the bucket to keep the grit out of your tools. You'll need about 10" of build space…
A 3D printed Tokaido coin to replace the cardboard ones included in the game. Traced from the actual game coin. Prints nicely on a resin printer; might print on a FDM with very short layer heights.
Holds a SimpliSafe alarm water sensor down in the sump pump pit where it can sense high water level before it overflows. Two designs: One to clamp onto a 1 ¼" PVC pipe and one to clamp onto a 1 ½" PVC pipe. Adjust the clamp so it's just…
This is a Logitech C920 Webcam Mount for a Prusa XL printer. The mount is primarily designed to have the camera in the right-rear corner of the printer since that's the clearest view of the printheads while printing. Since the mount uses…
Designed to keep a standard 4.5" tissue box from sliding around on the carpeted floor of a vehicle. Print and add some of the hook side of Velcro tape to the bottom to keep it from sliding on the carpet.
The Ariens snow blower heated handgrip kit has you install a new switch to turn the heated grips on and off, but includes no label for what the new switch does, so I created one. I left some extra space for the washer and / or rubber boot…
To wszystkie aktualnie dostępne wyniki.
