Liczymy pasujące modele…
This holds 18650 battery's together for making pack of 4. There is a relief at the bottom for the holder for any protrusion as well as the gap between the cells are 10mm to accommodate a Nickle strip. I used this for making quadcopter…
I have two files one of them has a 52mm opening and the other has a 54mm for shrinkage and for a loose fit. It sits flush in the drivers right vent and allows it to screw into the oem location. I will add a flat and angled version later…
This is for fans frames that are not square and are mounted on a standard radiator that has provisions for 120mm mounting points. When you have a fan shaped like the corsair AF120 or any fan that is not a square frame it will allow air to…
10 mm cap holder for 5MM standoff. (10.4mm x 5.1mm) My cap with heat shrink came to 10.8mm and i was able to squeeze it in there when printed in tpu. the less infill you print with the more it will stretch. Print Settings Supports: Yes…
Ls coil holder designed to hold 4 ls coils sideways. They were made to fit the standard ls2 coil that are flat and square body like the ones found in a corvette not the round body truck coils. The round coils may fit them but I have not…
There are 2 files one of them is for a 54mm opening for a loose gauge fit to be taken up by tape and the other is for sls or more accurate fdm at 52mm ID. these screw into the oem vent but it does not mount the gauge it only holds it this…
i couldn't find it so i am re uploading it. i did not create this Print Settings Rafts: No Supports: No **Resolution:** 200 Infill: 20 **Filament:** PolyMaker PLA Category: 3D Printing
Mustang with analog gauge. this is a oled mount and cover to mount the screen in the place above the oem display to not obstruct. The files have a screen holder and cover. i glued them together because i did not want hardware. i used…
this is a simple block for zip-tie wires ext on a 5mm standoff. This is ment for tpu but will print well in PP or PETG. Print Settings Rafts: No Supports: Yes Category: R/C Vehicles
VYFLY V2 Buzzer mount for a Flywoo Explorer lr. The buzzer mount that came with it is made for flywoo's buzzer and it is super small compared to the more popular vyfly. this will hold it and give you a hole for the button on the side. It…
To wszystkie aktualnie dostępne wyniki.
