Liczymy pasujące modele…
I needed a desk bench case and figured hexagons are cool. Sized to fit over my 1300w PSU. Printable in 300mmx300mm machines or larger. Voronoi legs and hexagon tray with CPU access oversized for various motherboard layouts. Made in…
A four week pill organizer I was requested to make. Extra large for elderly or disabled persons I used the lids from thing:2797494 and scaled them for the different design of my container.
***241mm x 295mm*** ATX Bench tray v2 with hexagons in hexagons, bonus shapes and curves. Supports a ~160mmx~200mm wide PSU under the stand PCI bracket is screwed on the edge. I used heatset inserts.
I needed labeled tray style drawers for Metric nuts and my stainless bolts. Using PrusaSlicer text on the label for various drawers.
Installing RO systems and needed some clips to have a bag of to hold down wires and ¼ tubing. Nothing I found had the fastner hidden and an easy way to remove the clipped wire/tube without removing the screw. After a few changes the…
Made it to print without supports, 250mm tall to fit most off the shelf printers, stretch it wider or taller for different geometry
Hexagon planter with 32 spots. Made to fit my CR-10 v3 bedslinger
Building a custom VZBot printer and needed to cover this circuit board. This is screwed to a sheet of acrylic panel so thus the flares.
50T Gear for a Nitro car spur gear
A Nitro Rs4 shaft gear combo part
Got the Mellow Fly-LIS2DW and needed a mounting bracket for the end of the nozzle. Just about over the RP2 chip
I've made an adapter for my enclosure to use P100 VOC cartridges and filters as a fume extractor. EDIT March 23' added a second layer and enclosure for some sound dampening and more filtration
Needed a clevis for the concrete finishing tools to go on the pole I already have. Standard threading for mop and handles, clevis with carraige bolt square on one side. 10mm slot width a bit beefy to deal with my use case
Raspberry Pi + Mellow Super 8 Pro + 4xHV-5160 external drivers. Added ductwork after testing mounting and grip. YMMV the fans I'm using are snug and haven't come loose. I'm sure someone smarter than me can make it better. Zip tie mounting…
Simple mounting tray for the Duet and Rpi. I have it laying on the base of my enclosure, could be easily modified for vertical and upside down config
Made a activated carbon filter system on a container, 80mm fan on the outside and this basket gravity held above it. The lid fits well, but has no latch, relying on gravity. Printed with .4 nozzle in CF PA-12 and it works great. I put…
7mm deep for E3D hardened nozzles I'm filling it with
Made to adapt to a large fresno float with a ID of 1 inch. Had to measure out the threads to get the pitch, printed horizontally so it doesnt get stuck inside and snap off. Same threading as the other rod end in my profile.
Made a zip tie everything cable run for my vertical run out of the rack for ~40 cables. Printed in half for added rigidity, use zip ties to hold it together
To wszystkie aktualnie dostępne wyniki.
