Liczymy pasujące modele…
This is a replacement knob for the KitchenAid stand mixer. It was designed with tight tolerances to eliminate the need for glue, I used a hammer to get the screw part inside. supports are needed around the edge. Don't forget to like and…
Just some lightsaber emitters I designed. Don't forget to like and post a make.
I designed this case for a binary clock that I built. The diagram and code for the clock can be found here (not my design) https://froggyist.wordpress.com/2013/06/24/building-a-very-simple-binary-clock/ Don't forget to like and post a make.
I designed this model to hang Kmobrain's Falcon 9 model on the wall. I designed it to be held up by small command strips. Pretty much any settings/material should work for this. A brim may be needed if you have low bed adhesion. Note:…
The stand for my Surebonder dual temp hot glue gun broke so I designed a new one. Supports are needed underneath the tab. I recommend printing this in petg. Don't forget to like and post a make.
To wszystkie aktualnie dostępne wyniki.
