Liczymy pasujące modele…
I modeled these using measurements from ABS 1-1/2" plumbing fittings. My goal is to make all of the standard ABS/PVC plumbing fittings, at least in the 1.5" range. These can then be printed very small to test build plumbing installations.…
This lightweight duct fitting fits onto a small size bathroom fan exhaust (fits onto 74.5 mm ~3" OD duct). The fitting then sweeps down to be itself 74.5 mm OD (just under 3") and turns a 90 degree bend and then continues straight for 63…
I couldn't find any 3D models of this 1970s classic, so I measured my “new” trailer and modeled it for printing. Just as the classic camping Boler trailer is made, this comes in two shells, top and bottom, along with a frame and wheels.…
2005 Toyota Highlander front cup holder spacer. This was made to replace the broken spacer in my 2005 Toyota Highlander so that two cups can be placed. Prints without supports
Classic pole-mount glass insulator, lovingly recreated.
Prints with almost no supports. ~95g filament @ 30% infill. Modeled for Danby dpa110dha1cp, but may fit other models. 4" hose to 5" fitting.
"Crimper" to fold 1/2" poly irrigation tubing to seal the end. Prints in 22 minutes! 3 g of filament at 30% infill, 4walls. Print with PETG for good outdoor quality.
Simple frame to fit a 4" x 6" postcard. Includes centred hanging holes. Just tape on the postcard from the back.
This adapter mounts as a lens to the Canon EOS (Rebel, etc). The tube end has an ID of 24mm, which slips over a microscope eyepiece, or eyepiece tube (prime). Tested this with my camera and it works well; objects focus sharp, even without…
Terrain map of Victoria, BC. Z-height is scaled 5x to bring out the hills more. Ocean is flat. Projection is fixed by scaling X-axis slightly.
Wall plate to cover large (2.5") hole in wall with 1/2" PEX coming out centre. Two identical halves fit together around pipe. Use CA glue to glue the two halves around pipe, then glue assembly to the wall (silicone?).
Replacement drive clutch and shaft for Oster 10-Cup Food Processor model # 2142966. This will require a 6mm metal shaft to be glued into the hexagonal printed “shaft”. The other end of the metal shaft, through the food processor bowl, is…
3D scan of a Jizo statue. It was a little off plumb so I've rotated it slightly. The slicer should fill in the bottom to sit flush. The real statue was about 80 cm tall.
I made this so that when I install single glass block exterior windows (7.75"), the block can sit on this flashing, which can cover the exterior siding. In my case that is cedar shakes. This way, any rain hitting the glass block will be…
To wszystkie aktualnie dostępne wyniki.
