Liczymy pasujące modele…
Hand crank winder for cross stitch and embroidery floss to wind them on the flat plastic bobbins. Uses 2 608 bearings to make it nice and quiet. Print instructions Print all with 3 perimeters and 30% infill Print the base and crank arm…
Case for the D1 mini clone and CC1101 with "rubber duck" antenna. Based on @RobinsBlog_de design, but I wasnt happy with a few things, such as the weird bottom and the hole on top not made for the rubber duck antenna. Using this to…
Replacement thumb latch for generic filing cabinet. The metal thumb latches eventually break off. You can pull the drawer above or below and use a tool to pop the latch to open the drawer. (Or pull the drawer above and reach in to…
The plastic strap holding the lines on the forklift broke, I took my calipers and made a new one. I will reprint in nylon once I get a spool, but this was done simply with PLA at 30% infill, 2 shells. 210 extruder, 55 bed on painters…
Holder for Loctite's Go 2 Glue. This holder keeps the glue bottle upside down and ready for dispensing. No more waiting for air bubbles to rise up. The holder also gives you better leverage to open the cap. Easy print even in 0.3mm layer…
Replacement buttons for the standard wall-mount control button for Genie Series II garage door openers. Sizing it to fit better, and fixing the holes. Version 3 needs the tabs shortened and button faces tapered a bit more. Attempt 4 was a…
To wszystkie aktualnie dostępne wyniki.
