P
PrintablesLordor5
Kerambit spiner keychain for 6703 bearing
https://stllink.pages.dev/
- Pobrania
- 771
- Polubienia
- 53
- Ocena
- 5
Wszystkie modele
Liczymy pasujące modele…
P
PrintablesLordor5
Mini surfboard for fingers
You will need a string to tie the board to your fingers and sand paper for a better grip. Have fun! https://stllink.pages.dev/
- Pobrania
- 512
- Polubienia
- 170
- Ocena
- 4,33
P
PrintablesLordor5
Karl Marx piggy bank
!Important! If you don't want to break the piggy bank to get the money out, you must cut with the PrusaSlicer tool to separate the two parts, as shown in the picture. Also, add connectors. Supports are needed, but you need to tweak a bit.…
- Pobrania
- 131
- Polubienia
- 20
- Ocena
- 5
P
PrintablesLordor5
BL/Cr touch mount for ender 3
A simple but effective mount for bltouch or crtouch probes for long hot-ends. I replaced my hot-end with this one: https://dvq4.short.gy/NXnCyr And now my config on Klipper looks like this: x_offset: -46.5 y_offset: -4 z_offset = 1.099 If…
- Pobrania
- 125
- Polubienia
- 3
- Ocena
- 0
P
PrintablesLordor5
Pixel 6 case
I recomend a support overhang Angle of 55º If you want to make a remix, I can give you the fusion 360 file, send me a mesage. https://stllink.pages.dev/
- Pobrania
- 121
- Polubienia
- 13
- Ocena
- 4
P
PrintablesLordor5
GX591 Spot Welder Case
A case for this spot welder: https://dvq4.short.gy/NRlgzA It's meant to prevent any type of short during operation, you can add a square of methacrylate to prevent anything from entering from the display side. The case it's meant to be…
- Pobrania
- 80
- Polubienia
- 9
- Ocena
- 5
P
PrintablesLordor5
Spool Holder whith ender 3 bearings
It's another spool holder but this one uses bearings obtained after replacing ender 3 rollers. You will need 2 ender 3 rollers because there is 2 bearings in each roller. If you are looking for ender 3 rolers, y used these while rearing…
- Pobrania
- 42
- Polubienia
- 6
- Ocena
- 5
P
PrintablesLordor5
Sofle custom split keyboard
This model uses this keyboard kit: https://s.click.aliexpress.com/e/_okGaGs3 And to connect the battery, you will need these clips: https://s.click.aliexpress.com/e/_oDhUe7p it uses standar M3x8mm screws if you don't have alredy I suggest…
- Pobrania
- 17
- Polubienia
- 6
- Ocena
- 0
P
PrintablesLordor5
Key spiner, print in place addon
It should be scalable upwards, but I haven't tested it, and I'm not entirely sure of its maximum scalability. Avoid scaling it in the X or Y directions to accommodate your finger better because it won't be effective; the holes won't align.
- Pobrania
- 15
- Polubienia
- 6
- Ocena
- 0
To wszystkie aktualnie dostępne wyniki.