Liczymy pasujące modele…
Divider for Milwaukee Packout Box large inserts. Modelled off another I found on the internet, refer the following link http://eikimartinson.com/archives/162-More-3D-Printed-Bins,-for-Milwaukee-Organizer-Boxes.html Recommend checking out…
Plasterboard cutout jig for Australian power points with notches to align with laser levels. Two small holes are 45mm apart to allow for quick drawing of 90mm holes. Print at .15mm, its thin enough that infill percentage has no real…
Feet extension for NZXT H510 case. No specific print instructions required, i did mine at 100% and PETG for strength and heat resistance.
End caps to suit 53mm x 10mm slats, with single prong centered on one side. Modeled to replace my cheap ones that keep breaking.. Prong is weakest point by far in design, besides drilling out bed frame to accommodate bigger prong, its…
A simple stand for nanoKontrol2 Midi controller. Print 2-off stands, one at either end of the controller. I ended up using double sided tape to hold these to my table so it didnt slide around when I used the sliders on the controller. The…
22.5 degree builders triangle Originally designed just as a rough guide for cutting cable tray at 22.5 degrees. Long slot is for a handle. Includes *rough* ruler denominations/increments (accuracy is printer dependent, and the slots…
Simple 5.25inch bay cover for this computer case.
Simple 3.5inch bay cover for this computer case.
Middle caps to suit 53mm x 10mm slats, with single prong centered on one side. Modelled to replace my cheap ones that keep breaking. Prong is weakest point by far in design, besides drilling out bed frame to accommodate bigger prong, its…
To wszystkie aktualnie dostępne wyniki.
