Liczymy pasujące modele…
Inspired by the camera mount by johanncc ( https://www.printables.com/model/146877-voron-0-voron-01-raspberry-pi-camera-mount ), I set out to modify his model to fit the RaspberryPi camera module 3. My modification caused the camera to…
This upgrade is used to remedy the increased resistance of the Thrustmaster T.16000M throttle after some time. It is possible to add magnets to the model to get magnetic detents at the 50% position. For this you have to glue the Magnet_50…
This is a complete set of sharp tabletop dice masters. It includes the following dice: D4 D6 D8 D10 D10 percentile D12 D20 How to use: Print the dice in resin. I suggest to support the dice on all edges facing the buildplate and…
This is a keychain holder for a Moto Tag. It uses a living hinge and a single screw to secure the tag inside the print. There are two versions of the file for different screws. M3x6 flat head cap screw M3x4 socket head cap screw
CAUTION : If you use the camera module 3, it might prodrude too far into the build volume. If you run into the same problem you might be interested in my center camera mount (…
Mount for nano sized cameras for the ZOHD Dart250. Friction fit to the fuselage. Needs to be rotated slightly to match the printbed.
Enclosure for the Raspberry Pi zero with HQ camera. As I had issues getting the correct screws for the model by Lilifee , I remodeled the enclosure to fit M2.5 screws with either button or cylinder head. To setup the camera you can follow…
This is an enclosure for housing a SHT3x sensor, LOLIN D1 mini Pro and a 18650 battery. The station is used to monitor temperature and humidity values and send them via WiFi to a home automation server. I use Home Assistant and the…
This is a rear lid for the ZOHD Dart 250. It fits an FrSky R-XSR and a TBS Unify Pro HV Race 2 including the corresponding antennas. With the heatsink of the VTX in the airflow it should not be able to overheat.
To wszystkie aktualnie dostępne wyniki.
