Liczymy pasujące modele…
Hinged lid stand for Flashforge Adventurer 5M (AD5M) 3d printer. Works with manufacturers' DIY enclosure - just unscrew screws and screw them back with this stand. When stand is not needed, it just laying flat on the back side of a lid.…
Plate dryer rack, compatible with IKEA RINNIG. Can be configured via freecad's spreadsheet by setting overall base length, thickness, etc. STLs provided are made for 220x220 mm build plate. Also has 2 inserts types - normal and long.…
Gravity laptop vertical stand (print in place) for notebooks up to 40 mm thick. Uses gravity to hold it vertically. Has 2 holes for rubber ring - to help automatic release (never tested though). Print 2 of them and you all set. Warning!…
This is slightly longer (+2 cm) version of my previous compact stand . Would suggest to print it with 3+ walls count for better rigidity. Would suggest to make them out of PETG, PLA would also be OK, but have doubts about its robustness.…
Wire antenna slim reel which can hold 10+ meters of wire (tested with 1.2 mm diameter silicone wire). consists of 2 snap-in parts. To ensure proper bridging, upper hole didn't cut through, leaving 0.2 mm (1 layer) for better bridging (at…
My original toaster's SilverCrest HG07747 clamp was broken, so I printed new one, but reinforced a little - to not break it again, using PETG. Print it as shown in pictures, with 4 walls, 4 top/bottom layers and 40% infill for sturdiness…
To wszystkie aktualnie dostępne wyniki.
