Liczymy pasujące modele…
The main issue with the SH02 is the bad fan noise. With these 2 TPU brackets and 2 m3x4mm screws or similar you can significantly reduce the noise of this great filament dryer! Print settings: 1 wall, 15% gyroid infill, 2 top layers, 2…
Version 6 is printed at a 45 degree angle to allow printing in a single piece.
I made a makerbeam 300mm 15x15 printable model because i didnt want to buy the makerbeams for making my own beamcase. After printing just remove the designed supports PRINT IN .22 LAYER HIGHT!! Print as showed in the screenshot I made…
you need 1 m3x8mm (or shorter) countersunk screw. print as shown in the screenshotyou need 1 m3x8mm (or shorter) countersunk screw. print as shown in the screenshot
Made this clip to attach a powerbank to my ubiquity umr ultra mobile router i used a metal magsafe ring. pause print after layer 8 to place the ring inside the model then continue the print . use .2mm layer hight break the designes…
UP Dosen halter zum Eingipsen mit 2mm spacer, damit die Dose ein wenig tiefer sitzt (Achtung! "kurze" Kaiserschrauben sind zu kurz dafür, man sollte die langen en wenig kürzen, damit die Schraube nicht herausrutscht)
modified the wheel to be smaller to fit my smaller landroid, NOT TESTED! original is 220mm, my version is 206.8mm
To wszystkie aktualnie dostępne wyniki.
