Liczymy pasujące modele…
If you want a vase with a drain, the Flat Top versions will work in vase mode in PrusaSlicer. Pointy Tops will not work with Vase Mode. We got the pointy tops and flat tops, with drains or solid bottoms. There is also a base plate to…
The original Articulated Shark was a little to wibbly wobbly in the up down articulation for my little nephew to play with. I added some additional parts to stiffen the shark out quite a bit. It is still just as wibbly wobbly going side…
This is a remix of the Sea of Thieves Megalodon by mordekain . I smoothed out a lot of the model to remove the semi-low poly look of the original and split it into pieces for easier printing. A very minimal amount of supports are needed…
Phone holder for a Jeep Wrangler center dash. I made it specifically for a Google Pixel 6a but It will probably fit a good chunk of phones, you may need to adjust the length of the spacer bar. I recommend gluing the spacer bar in place.
Options Pick the Coffin you want to use. Coffin No LED - Has a hollow back to allow some ambient light to pass through it. Coffin LED Strip - Supports strips up to 10mm wide, you might be able to squeeze a 12mm strip in. I didn't add any…
Knobs based off the mana symbols from Magic The Gathering. Self tapping holes for M3/M4 screws, depth of up to 14mm. So I'd say give yourself some clearance and add 12mm onto the thickness of the drawer or cabinet for the needed screw…
This will print in 1 piece on a Prusa MK3. I recommend either a brim or some support enforcers for the very bottom of the handle until it connects to the main can. Other than that, no supports needed. Edit: Added a version with a…
Support piece I made for my Gigabyte Vision 3070 to stop it from sagging. It may work for other GPUs. Default Height between GPU and PSU Shroud is 80.6mm. Default card width is 101mm. Fusion 360 file attached.
Fusion360 file included for modification. My Fan is 104mm wide (4 1/8 inch). Filter is 20x20x2. I used 3 clips just to ensure the filter was centered and secured, but 2 will do.
The Model This is my attempt for the Organic Supports contest. I tried to make the supports themselves be the primary focus of the model. Print Settings You will need to trim the tops/sides of the organic supports where they meet the…
To wszystkie aktualnie dostępne wyniki.
