Liczymy pasujące modele…
WARNING!!! It's a sloppy design, you shouldn't screw into a motor like that, because you can disrupt shaft & rotors allignment. Screws should be put diagonally, design should be remixed Instruction: Remove flex mount for motor, it's…
Original design has cracked and I've made this a much beefier model. But I don't recommend this or similar designs, because you can easily break bottom tip which is not made solid Print Settings Printer: Anycubic Chiron Rafts: No…
Wall hook for wide belts. 3 screws is way overkill, but I didn't care enough to change it. Used 5x25 dubels with 4x30 screws.
THIS IS A REMIX, ORIGINAL IS HERE: https://www.thingiverse.com/thing:3458332 For each case you need: 2x M3 nuts 2x M3 bolts (>25 mm) M3 dropnuts with bolts (and washers) also required for mounting (4 for single, 6 for double)
Soft magnetic jaws for 150 mm vice.
For assembly you will need: 2x M6x30 2x M6x70 (for adding strength) 2x M6 washer 2x M7 washer
I suggest printing the adjustable slot with 100% infill. For mounting you will need 4 mm diameter screws. Skadis clip does have some slack when inserted, if your printer is accurate enough, you can decrease the width of the slot.
I print them with 0.3 mm layer lines and adaptive layer lines at the top. Printed in PETG and PLA with different infill percentage for the same weight
I wanted to make some sparkling negronis as a gift to my friend and to present it I needed a box. I couldn't find an easy to make cardboard box for 4 bottles, for 6 bottles Corona box painted red would be good and I've done it, but now I…
Requires M6x40 screw and an M6 washer. I also added 2 o-rings, but I suggest using stainless hardware. 100% infill, supports from the build plate, 0.3 mm layer line
Parts are printed in different orientation and then glued together. Latches are 100% perimeters
To wszystkie aktualnie dostępne wyniki.
