Liczymy pasujące modele…
This is a generic carrying handle used to easily move my Voron 0.1. Can be used for all sort of stuff. The distance between the mounting holes are 120mm and the handle is 130mm long. It should fit most hands. Bear in mind, that the handle…
Ergonomic handle to fit magnetic bits which are held in place by a 6mm diameter and 4mm long magnet embedded in the handle. The magnet might need a bit of glue to stay in place inside the handle. I use it with a countersink bit. The…
I was not happy with the case ST designed, so I made my own. It was printed on a Prusa MK3S+ with 0.2mm layer height. It is quite a snug fit. The case is secured with a M2x4 countersunk screw. A dab of glue or a short piece of filament…
This holds up to 40 micro sd cards and is securely enclosed in the carry tube. It can be printed without support.
This part can be used to create exact hole diameters from a 3d printer
This may requires some sanding for the sliding to work properly. also the little bump and corresponding dent for the latching mechanism requires some smothing. In the best case just closing and opening a couple times.
Chuck which can be slid onto a shart of a nema17 motor and locked on with an M4 screw.
This is a snap mount with an optional screw to mount something rigidly on a 2020 V-slot rail. I used this to mount stuff on my ender 3 v2.
This model is meant to simply press fit on to the protruding lens assembly of the nothing phone (1). Some light scraping of the inner diameters might be necessary for a good fit. If too loose a bit of thin double sided tape can also be…
A stand to place your cup or glass on when you are on the couch. The fin is simply wedged between two cushions. Assembly: For assemly you will need three M3 screws. Length of the screw is not so important but should be at least 6mm for…
These models can either be used to mount a project box filled with activated carbon filter matts on the back of the anycubic photon to filter the nasty smells or to mount a air duct to move the stink outside.
To mount a Nucleo board to this only M3 screws are required. The holes are 11mm deep, so with the Nucleo attached at maximum a M3x12 screw can be used. M3x6 or M3x8 is probably already sufficient.
A container to collect all the victims of your mistakes.
It actually fits quite well and I have on in daily use, but didn't want to show a tooth paste covered dirty holder :)
This likely needs to be printed with a brim for enough bed adhesion. It also needs some sanding a the ends for the perfect feel. See the picture for what I mean.
A simple box. The knob attaches with a M3 screw, which is directly screwed into the plastic. In the photo are two boxes right next to each other
To wszystkie aktualnie dostępne wyniki.
