Liczymy pasujące modele…
I needed a funnel, so designed one in fusion 360 and printed it on my Anet A8 in ABS. Print Settings Rafts: No Supports: No Resolution: 0.3 Infill: 35 How I Designed This Category: 3D Printing
This is a small device for holding tie wraps or cable ties in place. It can be screwed down with a small screw or glued in place.
Rather than a bolt and washer attaching the clamps I designed this to go into the bed extrusion and secure the work with this clamp system. https://www.thingiverse.com/thing:2782653 Print Settings Printer Brand: Creality Printer: CR-10…
This is a stand for the Ipod Touch. You can connect the charging cable and still remove the Ipod if you want. Category: 3D Printing
This is an extension that can be bolted onto the Logitech G29 steering wheel to make the DRS switch more accessible in F1 2017 Category: 3D Printing
This is a dispenser that hold 2 rolls of solder with 2 guide holes to keep things in order and not tangled. I have epoxied this to my helping hands base and find it invaluable. Category: Electronics
This is a model to attach an air assist to a NeJe laser module that I have on my Eleksmaker laser form banggood. It is printed in PLA with the tube on its side. The main body attached via the four screws on the top of the laser module,…
I used fusion 360 to design this. I fould a petrol can lid on thingiverse, but the thread was not right, it was too fine and too many, so I designed my own. Check the threads. 3 revolutions 6mm section size 42mm diameter Category: 3D…
I designed this for 18650 batteries as singles or as a pack. Glue together using the male/female parts for multi cell packs. There is a cut out for nickel strips or wire ti connect them together. There is no need for support if you print…
I needed an external hard drive for my PS4 games and designed this to house the hard drive and it hangs off the PS4 when stood upright. It is printed in 2 parts and then super glued together. I used an old laptop hard drive and a…
A storage box for a credit card and SIM card. I use this to hold a CC and SIM that I use on holidays. Category: 3D Printing
Housing for a 1602 LCD with i2c module connected to an arduino nano and a DHT11 tempersature and humidity sensor. I use this to monitor the area around my 3d printers. I have included the Arduino code and a scematic. Category: Electronics
Ever had one of those cold calls saying, "your internet will be discontinued unless you give me all your hard earned cash", Well I get a lot of these scum bags so this is a little alarm made out of a buzzer, led, resistor, push button and…
To wszystkie aktualnie dostępne wyniki.
