Liczymy pasujące modele…
This is a simple display stand for a baseball. Baseballs can vary in size slightly, but not by much, so they should all fit. Show off that great "No Hitter" ball you earned or a great autograph you acquired. Posting photos of your printed…
Show off that "No Hitter" ball or a great autograph you acquired with this holder that is based on a three sided pyramid. Posting photos of your printed work with the baseball would be much appreciated. Check out my other baseball stands:…
This is a remix of https://www.thingiverse.com/thing:2576381 I've added counter-sunk screw holes to accomodate drywall screws. I would increase the print by 1% because the battery is pretty tight in the holder. But, if your batteries are…
Based on the following model from ewap https://www.thingiverse.com/thing:1896166 I found the model way too small to hold chili spice packets, Italian seasoning packets and ranch dressing packets, so I've increased the size. After printing…
Clemson University Paw Logo Disc. For two color prints, change to the second color on the 11th layer.
Baseball display stand based on a four sided pyramid. Show off that "No Hitter" game ball or a great autograph you acquired. Posting photos of your printed work with the baseball would be much appreciated. Check out my other baseball…
University of Michigan Coaster. The Photos look black, but they are a very deep blue.
This is a simple dual tube propagation station for starting new plants. Glass tubes not included. The bottom has dimples so the rounded end glass tubes will stay in place. The tube holes are 25.5mm. If you would like a larger, 4 tube…
This a remix of B_3D's Black&Decker 18V (Old) Battery Holder https://www.thingiverse.com/thing:5021043 When I printed B_3D's model it near impossible to get the battery on the holder due to it being tight. I've modified the design so that…
This is a remix of Iron_Scorpion Fishing Rod Rack ( https://www.thingiverse.com/thing:3700059 ). I found it difficult to print with the beveled edges all the way around the base. I've cut out the beveled edge so that it will print flat…
I was tired of all of the Yeti cup lids and other brand lids being all over the cabinet, so I put together this simple holder. For spice packets that are all over your cabinets, check out…
So, what we have here is a four tube propagation station for growing new plants. It's a very easy print. It is intended to be used with glass tubes that have a rounded end as there are divots in the bottom section to secure the tube. The…
This is a baseball stand based on a gear design. Show off that great baseball achievement, such as a "No Hitter" or "Strike out record" to your friends. Great for autographed baseballs you have acquired. Don't forget to upload a picture…
When I level my 3D printer bed, I use a ¼ sheet of paper, and this will hold those sheets.
Propagation station for three plants. Model is designed for tubes with a round bottom per the divots in the base so they are stable. For a four plant propagation station, check out:…
I'm not paying $10-15 for a replacement ball valve handle for a Hayward pool system again. I can print this for $2. I hope you find it helpful. This replaces the handle SP-722-F. 100% infill. 6 walls. Takes 4hrs 10 minutes at 50mm. PLA+
Tired of cup lids being all over your cabinet? Eliminate the clutter and keep them all together.
I prefer to cut up recycled paper into ¼ sheets with a paper cutter instead of paying for sticky notes. This holder keeps everything together. Print settings: .2 Layer Height Wall Lint Count = 3 15% Infill 100 mm/s 6 hour print time 72g -…
To wszystkie aktualnie dostępne wyniki.
