Liczymy pasujące modele…
My triplets needed to be exhausted out one window opening, so I modded these vents in order to daisy-chain them. These work with U.S. standard 4" dryer vent hose. There are two versions of each, one with hinges and one without (except for…
Adjusted the holding width, added some support structure, increased back-plate height to add more magnets (holding power) and added the Elegoo name I am not a designer, I just play with Tinkercad, so anything I create/mod/etc is/are not…
Modified the chute to work with hinges. The original chute would not seat against the printer body where the bottom screw is located when using the hinges. Use an M2x20mm buttonhead allen screw for the bottom screw. Also opened up the…
I wanted to use the larger 4-wire LED switch in the screen cover. I also added the Elegoo logo. I did have to cut a notch in the screen housing that slides onto the printer for the wires to freely feed into the machine. Also, use the…
Board alignment jigs 1/2in and 3/4in - original was metric sizes. All I did was resize in Tinkercad
This is a remix/mod of the 1288475-elegoo-centauri-carbon-yet-another-but-sturdy-riser. This is only the rear frame pice and slide door. All other pieces are used from the original designers Riser. Print the frame upright and print the…
Just wanted one-piece print for the trumpet for my son's boy scout mini-figs. Tree supports, a .4 nozzle and .2 LH with arachne wall gen. I may try at .2 nozzle and .12 LH for asthetics. I married the pieces in TC.
To wszystkie aktualnie dostępne wyniki.
