Liczymy pasujące modele…
This model requires a 6mmX8mm cylindrical Neodymium magnet to be inserted during the last few layers of the print. Pause and print was not necessary and the magnet could easily be inserted during a running print. It is recommended to…
A generic handle with through holes to screw it in. It was printed with a 0.28mm layer height. No supports needed.
This rescues you when you fall just a bit short of comfortably opening your attic window (from Velux specifically in this case). I was inspired to get back to the drawing board after using the part from…
A small bump has been added on the inside surface so that the token stays in place with a 'click'.
Many a times I end up using this portable desktop amplifier at home with my PC and its quite annoying to adjust the volume when its laying down flat on the table. This issue is now solved with this snug fitting angle stand. Print Settings…
To wszystkie aktualnie dostępne wyniki.
