Liczymy pasujące modele…
Model airplane hanger that holds the aircraft by its wheels. Fits any wheels up to 110mm in diameter. I used drywall anchors to hold it to the wall. I have had it up for a little over 3 years now and I haven't seen any trouble with it…
Vent mod for the Sunlu Filament dryer S2 with adjustable opening. Print the cut layout piece first to mark out where to cut on the lid and where to drill the holes. Bolts are M3x10 with a nut on each. I recommend removing the lid entirely…
Ender 3 webcam mount for ONN ring light webcam. This will also fit any webcam that has a base width of 13mm. Remixed from https://www.thingiverse.com/thing:4622926 I am not sure the exact screws I used but they are commonly found in…
It's a hammer. You hit things with it.
This model is designed to allow the user to place the mustard bottle on its end so that the mustard runs to the cap. Since everyone's printers are a bit different it is suggested that you create your own g-code instead of using the one…
IMPORTANT: you will need all the regular parts from kevinakasam's belted z mod but substitute file “1_leftV3.6” with the version I made and print the additional cable holder piece. I just used some random screws I had on hand but you can…
Broom holder designed to clamp onto any 2 by dimensional lumber. must be printed in orientations shown in the gcode files. If not printed in that orientation the gear will not slide freely.
Use suction cups to hold this onto window. V1 is designed for use with a small container insert. V2 is its own cup. Place grape jelly in the cup for feeding them. If your interested in a remixing and you would like a .ipt file let me know.
! ! Important information ! ! These are designed to be put on 2 by lumber found at a hardware store. The opening therefore is not 2 inches. It will be hard to push onto the board. This is by design. To prevent the hook from slipping off…
Bracket to hold the needle valve used to regulate the air for the air assist. Uses 2 m3 bolts to mount the valve to the bracket and 2 m5 bolts with t nuts to secure the bracket to the frame.
Mount for kusba accelerometer that mounts it to sprite extruder hotend. Required hardware: 1x M3x8 4x M3x12 Some M4 nuts
To wszystkie aktualnie dostępne wyniki.
