Liczymy pasujące modele…
This is a pegboard mount for the JBL Extreme bluetooth speaker. Fits versions 1 through 3 of the JBL Extreme series speakers. using standard 1" spacing for the pegboard holes. Supports recommended for the pegs. Infill: 60% Filament brand:…
M2 and M3 standoffs for FPV drones in common sizes. Material Details: Supports: No Infill: 100% Filament brand: Hatchbox Filament material: PLA
Tail mount for iFlight Chimera 7 frame. Includes space for DJI air unit dual RP-SMA connectors, TrueRC Bardpole, BN880 GPS, and TBS Crossfire diversity RX. Thing contains two versions, one with cutout for power to be brought topside via…
This will take a 1lb spool of solder, solder sucker, and a flux pen along with 12 soldering iron tips. No supports needed during my print, but speed may need to be reduced for the last bit of the arch. Infill: 15% Filament brand:…
I've created a variation of the case top of the Rugged Multipart Pinecil/TS100/TS80 Case (V2) which features the logo for Minware, the original creators of the TS80 and TS100 soldering irons. No supports needed during the print, and a…
Dust Cover for female SMA antenna receptacle found on the RapidFire module. Fit is tight enough that it will not fall off accidentally. Print Settings Printer Brand: Prusa Printer: I3 MK3S Rafts: No Supports: No Resolution: 0.15mm Infill:…
This part is intended to be used as an insert for the Pelican G5 RFID wallet. The case contains space for 2x Yubikey 5 and 1x Yubikey 5c devices. No supports needed during the print, and a layer height of 0.2 is recommended. Infill: 15%…
This part is intended to be used to mount a TBS Minimortal T antenna Rotor Riot Bubito frame. Parts should be printed using TPU/Flex (Sainsmart recommended) with a minimum of 80-100% infill and .15 resolution.
These parts are intended to be used to mount a camera in a sleeve such as the insta360 Go 2 to the BQE RipSqueak v2 frame. Parts should be printed using TPU/Flex (Sainsmart recommended) with a minimum of 70-80% infill and .15 resolution.
The Black Dog Cycle Works Helo Pad leaves holes in the top surface when a rotopax is not in use. These plugs should help stop precipitation from getting into the rear cargo compartment when nothing is being carried on the rack. While…
This part is intended to be used mount 2x1S batteries to a Happymodel Mobula 7 v2 frame. Parts should be printed using TPU/Flex (Sainsmart used) with 100% infill.
This shim allows you to securely attach the parts tray included with the Goehner e-bike repair stand to the upper smaller-diameter pole. It's a simple and effective solution intended to bring your tools and hardware closer to where you…
To wszystkie aktualnie dostępne wyniki.
