Liczymy pasujące modele…
Mudguards for the front wheels to prevent soiling from whirled up grass cuttings. The parts are only placed on the wheel suspension dome and should be held in place by themselves. The mudguards are curved upwards on the outside to ensure…
Mudguards for the rear wheels to prevent soiling from whirled up grass cuttings. The mount is placed over the axle and secured at the bottom with a screw. The mudguard is pushed over the dovetail onto the mount. I've printed them with 0.2…
This is a very stable low poly remote control stand for three Remotes (2 bigger ones and 1 Fire TV) To save time you can print with an extrusion width of 1mm and the support cubic infill. The model does not need supports
A twisted stand for drying the Sodastream glass bottle. Designed in Fusion360 and printed with PLA Black without any supports.
Two small, quick-print battery lifters for those who find it too fiddly to get the batteries out of the box. One for AA and another one for AAA Batteries.
This is a remix from the YogiTechs paper towel holder, just for a hanging mounting with a shorter base for a better and more compact looking. Don't worry, the springs won't fall. The tolerances are very good to hold everything in place.
New smaller cutting disc fot the mammotion Luba Advantages: Enlarged cutting surface thanks to longer blades Lighter than the original (<100g), therefore smoother running and less motor load Very quiet in operation Improved cutting…
A short wrench as a knob replacement for your LCD Printed with Prusament PETG Print with supports activated
A new knob for your prusa mini in a simple wheel design. Printed with Prusament PETG 0,15mm Quality No supports needed
Housing for an Aqara water sensor with external rain sensor. The housing is designed to stand upright with an inclined sensor surface. The following Rainsensor can be used:…
I made a very simple mowing disc for 5 blades. For mounting the blades you will need 5 M4 melt-in threads. I printed with PETG, 0.2mm Layheight, min. 4 Perimeter and 25% Infill. The disc runs very smooth with very little noise
This is a wheel rim to widen the wheel contact area and improve the robots mobility. I printed with Prusament PETG, 0.2mm Layer Height, min. 4 Perimeter. You need 4 M3 melt-in threads for mounting the rim to the original wheel. The…
To wszystkie aktualnie dostępne wyniki.
