Liczymy pasujące modele…
Designed this for the large 2x 48v 280ah banks. Clips on decisively to the standard busbar with inside barrels that align with the standard nuts. Small cut outs in the terminal cover for the BMS sense and balance leads.
I designed this mount to fit on top of our battery bank, to mount the JK BMS battery balancer. But could be used to mounting to many surfaces. very secure to the balancer with the normal mounting screws, but gives a better mounting…
This is for the secure mounting of the LILYGO POE esp32 board and a BME/BMP 280 sensor board. The main case, with brass inserts, allow the board to screwed in, exposing only the POE port to the bottom of the case. The lid snaps into place…
A couple of brackets I designed to mount a linear actuator to open and close a vent flap. Could be useful to someone! On the motor mount needs supports, i used tree with no problems. Printed in ABS, the motor mount is designed to use a…
A simple 19" rack mountable case for a 4 port QC3.0 board : https://amzn.to/3DWd83l
Used to hold together a rotary battery isolator switch and a HRC fuse for use in our battery design. Allows for a copper bus bar with correct hold to be mounted and m10 bolts to be used as terminals for the fuse and main terminal!…
Designed for the bottom of the container, and with some other 3d printed parts, pipefittings and gravel this can help filter grey water - in a small footprint - to be pumped into a storage container. Used with:…
With m3.5 brass inserts in 4 clips they clip into the sides of the backbox for some adjustment to the fitted switches or blanking panels. 20mm punch outs for conduit or screw glands and a few cutouts for screw fixing. This is a template…
To wszystkie aktualnie dostępne wyniki.
