Liczymy pasujące modele…
A desk tidy with slightly angled shelves and two spots on the bottom to attach to a desk with 25mm VHB tape (0.6mm indents). Print on its back (Hex side). I recommend 3D honeycomb fill with 10% infill and 3 walls/top/bottom. No supports…
Keep pumps reservoir organised with this minamalist holder. Printing is fine with 2 walls, though i recommend 3 for the top, and a 0.12 layer height so the slope has a higher resolution. Ideal for storging the reservoir in the fridge…
A Small collection of accessories for the Modular 10 Inch Server Rack - Reworked project. These have yet to be printed, so no guaranties that they work. The included models are: 200mm Fan Topper An Alternative topper that's designed to…
1U 12x Keystone ports with or without shelf to match the Modular 10" inch server rack project I recommend printing the test piece first to ensure your keystone modules fit well, as this was designed to fit a CCS brand module.
A toothbrush holder for the Oral B IO series of toothbrush heads. This design features slight indents that allows the toothbrush to snap into place with a satisfying click. Double sized tape or a command strip should be used to hold this…
A Spectra S1+ pump bottle holder, with no fixtures required. I suggesting printing in PLA with 0.16 or lower layer height to ensure the threads print correctly. Print upside down with thin tree supports for 20 degree overhang. 20% infill…
This enclosure “Sonoff MINI box” fits all of the mini sonoff “DIY smart switch” range: MINI-RBS ZBMINIR2 MINI-ZBRBS MINIR4M MINIR4 Select the alternative model “Sonoff ZBMINIL2 ONLY” for the ZBMINIL2 , as this is a few mm taller. The…
This topper is split into two to allow it to print on a 220mm wide print bed, either side has a 30mm deep and 6mm wide hole to allow for a 6mm woodern dowel (or a 3d printed one), to be glued into place to join the two sides. This has…
1U Mounting panel for a TP-Link TL-SG108 to match the Modular 10" inch server rack project
A no-supports needed print to hold your docking station & laptop vertically. This is designed to perfectly fit the dell WD19TB thunderbolt 4 dock, keeping all I/O & air vents clear. It can also support a laptop that's at maximum 23mm…
3x 25.5mm gluestick holders for the Skådis Pegboard. Idea for Creality Gluesticks. Print with supports for the pegs
A Spectra S1+ pump bottle holder to keep your bottles upright in the fridge, or to carry them around. I suggesting printing in PLA with 0.2mm or lower layer height. 6% TPMS-D infill works great. Two models are available, the only…
A small (75mm) strainer for your sink so you can wash loose leaf tea from your tea pot without them going down your sink, then they can be put into food waste once strained. I recommend printing from a more temperature resistant material…
To wszystkie aktualnie dostępne wyniki.
