Liczymy pasujące modele…
A modification to the heater control panel for the BMW E30 to have the radio flush with the control panel. This adapter sets the radio ~7mm back into the dashboard. To be able to use this adapter piece, you will need to modify your heater…
I designed a base plate for the Tintin Moon Rocket by Muth, found here https://www.printables.com/model/163971-moon-rocket The original model states that you put a LED at the top of the smoke cloud powered by a USB cable. However I didn't…
It's possible to use the electrical motors and switch from a Ford Fiesta to retrofit these onto the BMW E30 headlights. Removing the hydraulic actuated headlight aim adjusters which tend to leak after all these years. The bracket makes it…
Two brackets to mount a EU powerstrip (KF-FB-03K) to the underside of a table/desk with the help of a couple of screws. Since I had a hard time figuring out how big other brackets online are, here's some dimensions of my powerstrip for…
I didn't like the look of the rubber cover that came with the MOMO hub, so I designed a smooth version. Printed with a 0.2mm layer height, I modelledthe bottom of the part 0,2mm thick to have good bed adhesion. This part needs to get cut…
Replacement cap for the brake fluid reservoir on a BMW E30 325iX as these are no replacements available any longer.
Printed dia to press a reinforcement rib into a sheetmetal plate. I used this for a BMW 2002 for the rear floor where the subframe bolt is.
A piece broke off from the trunk side panel on my E30 Touring (outer section of the lock) As it's an iX model, the right panel is different and hard to find unlike the normal E30 Touring cover panel, I decided to model a piece to repair…
Reverse engineered HP Photosmart 5510 paper holder/bracket.
I designed a tray to organize the CP bolts for my Kovosu welding-fixturing table. The bolts are slightly tilted to have easy access and also make the height lower to it fit's most tool boxes/chests. This model is designed to be used for…
I designed a tray to organize the eccentric discs for my Kovosu welding-fixturing table. With this tray it's possible to store up to 6 discs. This model is designed to be used for the K22 series (discs have an 75mm outer diameter)
I bought a 1/2" spline socket set but it came with a cheap plastic tray so I modeled a sturdier tray with it's accompanying cover to house the sockets. Socket sizes M10-M18
To wszystkie aktualnie dostępne wyniki.
