Liczymy pasujące modele…
I've designed this holder to be more suited for a smartphone in a case (etui) which makes it quite thick. It is easy to place and remove. If you need to make this holder more suitable for your phone, you can simply scale it a little bit…
Holder for a car trash (from Baseus), that can be mounted e.g. on the side storage of the car. The first design (large) was meant to be printed in PLA or TPU, but it appeared to be too long, and the trash was crashing while closing the…
I created that cutting board holder to save some space in the kitchen workspace. The holes are designed to fit 3 mm screws, and the additional holes (in the bigger part) are designed to put a screwdriver while mounting. Printed with PLA+…
I have created this simple design to utilize a very cheap LED light for a plant growth support. The strip is 8 mm wide and 50 cm long, using USB power supply (powerbank, phone charger, laptop etc.). Due to that design's modular nature,…
Simple organizer created for 3x USB chargers and 3x pendrives in two versions. First (simple) is presented on the photos, is designed to be mounted using two-sided tape or screws (requires making holes using driller). I used both options…
I have designed anti-scratch pads for Ikea KVISTBRO coffee table. The model is designed to be printed using flexible filaments (e.g. TPU). You can resize it slightly to optimize the inside diameter. Photos present 100% scale printed in…
Imilab solar panel balcony railing mount: These parts are designed to have ~0.1 mm offset, for better stability use rubber/silicone pad (see photo, black part). The mount is secured by cable ties. I have printed these parts as drafts (0.3…
To wszystkie aktualnie dostępne wyniki.
