Liczymy pasujące modele…
Small old school galvanized trashcan based on those seen in 1980's 1990's movies and TV shows. I have printed this in vase mode at 0.1, 0.2, 0.3, as well as variable layer thickness, and have found that it is plenty rigid enough for my…
Here are some 19" server rack blank plates sized at 1U, 2U, and 4U that should save you a few dollars over purchasing from Amazon or Monoprice. I printed these in PETG at 0.2 with 20% infill, but do whatever works best for you. You'll…
Print as two separate parts. The lid can be printed upside down so you don't need supports. then glue them together (I used CA glue). There are keystones and registers to help with alignment when gluing. They will not hold the lid on…
Simple multi-material “no soliciting” sign. I plan on using two eye screws and hang it using some wire. Printed in PETG since this will be outdoors, but can be done in PLA. 0.15mm
Easy print board game organizer for Pandemic Legacy with room for expansion as you play. Fits in the original box. Print the pieces you need!
Print at any layer height, and about 10% infill
I printed this model in PETG, 0.3mm, at 100% infill, but you probably can get away with less. This model is made to be mounted to a stud, and not with a drywall anchor.
It's been about 10 years since I had a handi-snacks and just found out that Ritz, for reasons that I can only see as shrinkflation, decided that they'd remove the indestructible rubberized-plastic red stick that you'd use to conveniently…
To wszystkie aktualnie dostępne wyniki.
