P
PrintablesDaPaulus
Nema17 Motor Cooler
A fan mount for a 30x30mm fan to mount on a nema17 motor. The mount is 38mm at its widest and adds 2mm between the motor and the motor mount.
- Pobrania
- 100
- Polubienia
- 28
- Ocena
- 5
Wszystkie modele
Liczymy pasujące modele…
P
PrintablesDaPaulus
15.6inch Monitor (Reference Model)
This is designed after a cheap 15.6 inch monitor I bought on Amazon. It has a VESA 75 Mount on the back. On the left side I modeled the On/Off as well as the menu selector. There is also a 3.5mm headphone connector. On the right there are…
- Pobrania
- 51
- Polubienia
- 4
- Ocena
- 0
P
PrintablesDaPaulus
LBoxx Box Insert 1x1
A 1x1 insert for the LBoxx system. It sits flush with the lid so that the contents of the boxes can' mix. On the bottom it has a structure that grips into the grid of the LBoxx system to avoid movement even if there are no other boxes…
- Pobrania
- 24
- Polubienia
- 8
- Ocena
- 0
P
PrintablesDaPaulus
LBoxx Box Insert 2x1
A 2x1 insert for the LBoxx system. It sits flush with the lid so that the contents of the boxes can' mix. On the bottom it has a structure that grips into the grid of the LBoxx system to avoid movement even if there are no other boxes…
- Pobrania
- 20
- Polubienia
- 9
- Ocena
- 0
P
PrintablesDaPaulus
Fancy Double Dip Vase
The model contains a internal structure as you can see in the second image. I chose to do this to be able to print this without any supports that would have been otherwise needed on the inside. If you want to make the vase heavier you…
- Pobrania
- 12
- Polubienia
- 1
- Ocena
- 0
P
PrintablesDaPaulus
Fancy Dip Vase
The model contains a internal structure as you can see in the second image. I chose to do this to be able to print this without any supports that would have been otherwise needed on the inside. If you want to make the vase heavier you…
- Pobrania
- 11
- Polubienia
- 0
- Ocena
- 0
P
PrintablesDaPaulus
Floating 3D Pinter Feet
This floating feet uses a 16mm glass marble. The size of the marble is quite important since the bowls are designed for a 16mm marble. The upper two parts can be printed from any sturdy material. I used PLA works fine. The lower part…
- Pobrania
- 7
- Polubienia
- 0
- Ocena
- 0
P
PrintablesDaPaulus
Vesa75 Angled Top Mount
This mount is designed to hold a 15.6 inch monitor underneath a wallboard on my desk. Hardware needed: 4x M3 Washer 4x M3x8mm Hex Screw 6x M3x10mm Hex Screw 6x M3 Heat insert Maybe 1x Strip of double-sided tape to stick the monitor to the…
- Pobrania
- 6
- Polubienia
- 0
- Ocena
- 0
To wszystkie aktualnie dostępne wyniki.