Liczymy pasujące modele…
This mount is attached to the back of the Neptune 4 Pro toolhead (Probably compatible with other Neptune 4 printers, but never tested). It uses the original mounting hardware and clips in on the mounting holes for the part cooling fan. It…
Each module is on a 10 degrees angle and can stack on top of eachother. The cutouts on the side can be used to fasten the modules to eachother, but it is not necessary. The fastening brackets use m3 screws. No need for extreme long screw,…
The angled bit holder allows the model to hold full length bits at the cost of the amount of bits it can store. I recommend adding some small magnets in the bottom to hold the bits secure and to stop ratteling, but the bits can't get out…
This model gives the spool holder a solid body for extra strength and reduces friction on the spool itself to lessen cardboard dust on the buildplate. Usable for spools 70mm wide of less
To wszystkie aktualnie dostępne wyniki.
