Liczymy pasujące modele…
I originally designed it to be a sand castle, but it can be a miniature castle if you use a different color. I used a 0.8mm nozzle and thick layer lines since it's a big print. It doesn't need much infill either.
I created this rotating sign for my office door and now I'm sharing it with the rest of the world! The best part is you don't need a huge printer, special filaments, or support material, but you will need some components: 7 magnets 5mm…
The little nubs at the bottom are supposed to simulate wheels. Category: Buildings & Structures
A trash bag hook that fits to the glove compartment of your car so you don't have to hang it off your shifter. I designed it for a 2024 Toyota Corolla, but it might fit other cars. I recommend printing with a UV and heat resistant…
This is a box to hold your cards for Flip 7. I never liked the box that the deck originally came in, so I made my own! I do like to swap out the filament after about two layers to get a nice contrast for the label on the bottom.…
Just a staircase I made for a project. Due to the program I used, the blue model will look sideways. Category: Buildings & Structures
Where I work, a lot of the teachers use document cameras to show worksheets or read books to students. I noticed that a lot of them were boosting them up with things like books or boxes, so I decided to make something purpose-built for…
Just an archway I made for a project. Category: Buildings & Structures
Now you can 3D print your own treats for Spots! Super simple print. I used a 0.25mm nozzle with PLA.
A replacement rear fender for the Jupiter Discovery X5 electric bike. I ended up gluing it to the rear strut, but you may need to add a zip tie or two since the brake line can get in the way. Recommend using a UV-resistant material such…
I was inspired to make this design after organizing my spices and realizing how deep my shelves were in my pantry. With this spice rack, you can push the spices down the track to allow them to rotate around and easily reach the containers…
A USB drive holder that fits perfectly into the older Ergotron charging carts. Holds up to 4 drives. If you print it on its front face, it doesn't need any supports. PLA works fine.
Pieces print separately and can be glued together. If you have a multimaterial printer, you can skip the painting, but I could only print in one color. You might need supports for the letters, but depending on your slicer settings, you…
To wszystkie aktualnie dostępne wyniki.
