Liczymy pasujące modele…
Simple travel blade cover for a Gillette Fusion 5 Proglide Razor, might fit some others The fit is quite firm as is, no other retention method needed as the head has rubberized sides No need for support material, print as is with the…
Either: 1) Print the handle alone, should be a drop in replacement A 2 layer raft is quite necessary I fear. With a print this small it's not a concern though. Or you could slice a bit off to have a flat surface to rest on, at the cost of…
Wanted to make a very clean and bespoke phone holder, hate the ones that clip into vents or whatever and then flop around and look ghastly, this is much classier imo The holder just clips in over the trim piece as shown, clean and strong…
Print without supports but give it a few extra perimeters for strength. The head of the breaker bar just sits nice and securely in the pocket Designed to mount with a single screw to a wall. I'd advice against using anything weaker like…
This is a proper canopy for the FT Spitfire, was quite a pain to model, but I think it looks absolutely awesome. I recommend printing with 2-3 perimeters and sparse infill, maybe 5%, just for stability. Prints on the back face, no…
Used set of DT770s came with one of these rings missing, so I whipped up a replacement. Yes you can get replacements cheaply because Beyerdynamic is cool, but I wanted one now )) If I remember it snapped right in nicely, but thought I…
To wszystkie aktualnie dostępne wyniki.
