Liczymy pasujące modele…
Paint rack designed to hold Vallejo Paints (25mm diameter) at a 45 degree angle. Designed to hold them in a very specific paint box I have. Also has a slot in the back to hold over flow.
I have been cursed by a wizard and am forced to redesign my paint organizer once a fiscal quarter. The latest iterations turns a cheap spice rack into a paint holder for 48x 25mm diameter paint bottles. The mounts use captive magnets to…
Compact travel case for my 8mm diameter brushes. 6 holders makes a case about 60mm in diameter. It uses 3mm filament as a peg in the hinge. They click together with 8mm x 2mm magnets. There is space for four magnets in each one, but you…
Wargaming mini bases sized for 24mm, 28mm, 32mm, and 75mm x 42mm. Slot for 8mm x 2mm magnet in bottom. designed to be printed top down, no need for support. Also has a small cut out along the rim to aid with picking the mini up.
3inch x 2inch x 1inch gauge for a kill team travel kit.
Small tray for holding bases. Use in miniature painting for base coating or air brushing. Use 3.15mm wooden skewers (I used ones I had for barbecuing). The skewers are 12 inches which should keep the paint off your hands. The design can…
Docking Station to charge my steam deck and connect it to ethernet. Uses a cheap Lasuney usb-c hub I liberated from work. Slot for the dock is about 16mm by 56 by 120. Have cut outs for the vent, HDMI, USB-A, and Ethernet Ports. Design is…
DIY Paint Cup with runnels on the edge to wick off water, it fits on top of a jar. Was trying to make a not legally actionable paint cup similar to GW's version, but not 15 dollars (please don't sue, I'll give you money via Drukhari…
travel wet palette, prints as one piece. Uses 16 2mm by 3mm magnets to hold the case shut. the bend radius is a bit too wide, so you need to break it in a bit before it will sit shut. Has some integrated dry brush texture.
Uses a single sheet of roof flashing (127mm x 178mm x .5mm) as a plate to hold magnetized miniatures vertically. Has four legs on the bottom to hold the plate up, and pegs to hold 19mm (outer diameter) washer. The washers act as a plate…
When my bottle of Tamiya is about 50% full it gets tricky to get the brush waaay down there. I designed this lil guy to tilt the bottle. This makes it theoretically less likely I'll knock it over and spill the remaining 50%. There is a…
Top portion is 85mm wide, bottom is 81mm. Prints as two parts, either glued or held together with a small bolt.
A small laser line unit for measuring line of sight in wargaming. Lading [Business word for stuff you Need]: AA Battery Pack Powered by one of these AA battery packs USB Volt Reader Uses this little USB volt meter to read the charge, not…
To wszystkie aktualnie dostępne wyniki.
