Liczymy pasujące modele…
Generic GPU support to prevent sag without attaching to anything specific. Works best in a PC case with a power supply “basement” PLA has held up just fine for this and it prints faster lying down than standing up. The model is meant to…
I needed a box to house the MKS Mosfet that went with the MKS Gen v 1.4 and didn't find any that I liked so I made a new one. The lid should pop on and off with locking tabs. There are 2 options for each part. The Lid Passive ventilation…
This is/are the end piece(s) for the y axis the P3 steel i3 frame. They brace the y axis rails in place. Printed in PETG .25mm layers with 4 perimeters and 33% infill with Superslicer on an Anycubic Mega S. You'll need 4 of these and…
I made this piece in Tinkercad by measuring the broken piece that I found on an old P3 Steel I3 in someones garage. The original piece had sharper edges but i expanded the model a bit and added rounded edges. The 4 nubs/pegs are a tight…
To wszystkie aktualnie dostępne wyniki.
