Liczymy pasujące modele…
You can either print it and stop to add the steel washers of the original model or use a smaller washer and push through the top with the screw you will use. Print in TPU using a 35% infill i was able to get 95A to squish and remain strong.
This is a vertical mount for a fire extinguisher can, or any standard household can it should fit standard aerosols including hairsprays. Remember fires can start anywhere in your home place near doors and entrances so you do not get…
Print at 0.20mm 2 x M3x8 flat heads needed for the lilygo side Double sided tape needed for the mount. No supports needed for the circle mount supports are needed for the rectangle mount. The rectangle stl should be printed so both the…
Uses 2 0.75" x 1/8" Neodymium Magnets. Recommend to use glue to hold in place but should friction fit as well. No supports needed recommend using ASA/ABS but PLA will work in non Heat Sensitive environments. The mount can be double sided…
This is to solve an issue I ran into with an old switching powersupply designed for Molex 9 pin, but I use PowerPole Connectors on my gear. I realized that 2 powerpoles were close in size to a 9pin molex connector and wanted a way to hold…
To wszystkie aktualnie dostępne wyniki.
